Add:ZAOZHUANG CITY SHANDONG CHINA
E-mail:sunlong@lienhoawood.com
Tel:+86-13792981260
SHANDONG LONGHE WOOD CO., LTD.
Fax: +86-632-5780777
Con:SUNLONG
Copyright © SHANDONG LONGHE Wood Co., Ltd All Rights Reserved | 鲁ICP备18046861号-1
NEWS
Wood veneer processing method
[Abstract]:
When the veneer veneer is bent, the back groove is generally used, and the groove is opened to a depth of about 2 mm from the surface.
When the veneer veneer is bent, when the bending radius is large or the plate is thin, it can be bent by hand without using special equipment, and then fixed at the connected position. If it is a plate with a thicker bending or a small bending radius, it is equipped with special equipment and processing methods, sawing or cutting a piece on the inside of the board, embedding a corresponding piece of wood or wooden strip, and cutting out the gap. Bend again. The time for press forming the veneer veneer should be based on the radius of curvature and the thickness of the board.
For example, a thin sheet material can be completed in a few minutes when the moisture content in the sheet is increased and the mold is used to assist the pressurization.
Previous article:
Selection of veneer veneer furniture
Wood skin veneer quality identification method
Next article: